DEVPUMPS PCF-series Centrifugal Pumps are Horizontal,  Single Stage, Volute Casing Pumps, Dimension Corresponds to DIN-24256 / ISO-2858 with end suction, Top centerline discharge design. Back-pullout design,  enables to remove the rotor assembly without disturbing the pipe lines. If a spacer coupling is used ot is also unnecessary to disconnect the motor. The feet at bottom transfer residual pipe stress by the shortest possible route the base plate & foundation.

The PCF range compromises of 32 pump types with 3 shaft sizes which cover the entire range with maximum interchangeability. For Pumps belonging to a particular shaft size, shaft, shaft sleeve, impeller nut and bearings are interchangeable.  Closed / Semi-0pen redial impeller specially design for law NPSH requirements. The Impeller are hydraulically balanced by back vanes, or in the case of larger impeller diameter by renewable wear ring  at both ends and relief holes. Impeller is locked by Dom nut to reliable fixing.  The pumps shaft is guided on oil lubricated angular contact and cylindrical roller or ball bearings.
The shaft is fully protected from the liquid to be pumped by means of fully enclosed by PTFE gasket between impeller nut & Shaft Protecting Sleeve.

The Pumps are supplied with either  gland packings or mechanical seal in stuffing box with connection for sealing and flushing arrangements. Single or Double Mechanical seals are fitted as per API plan and depends on liquid nature and pumping under vacuum. The jacketed stuffing box design are useful for cooling of  gland packings or Mech. Seal while it run under  high temp. The above pumps are also available with steam Jacketed Volute casing & stuffing box while pumping liquid is in crystalline in nature. 

The direction of Rotation of all pumps are clockwise direction from drive end. Above pumps are also available with close coupled design ( Mono-block type with motor ) on special request to eliminate space problems and alignment problems.

For pumping of  Corrosive & Abrasive Chemicals, Hydrocarbons, Slurries, Hot Oils, Thermic Fluid, Slurries , Volatile liquids in Chemicals, Petrochemicals, Textiles, Sugar, Paper, Fertilizer, Pharmaceuticals, Process Industries.

Up to 400 m3/hr

Up to 100 Meters

Material of Construction :

As Per ASTM / DIN Standards

• Cast Iron
• Carbon Steel(WCB) / Alloy Steel
• CF8, CF8M, CF3, CF3M (SS316L), ALLOY 20, CD4MCu
• Hast Alloy B / C